Xscope bpro update#
Xscope bpro software#
Xscope bpro download#

The Keypad on the X-Sight is designed to be tapped not pressed and held! When using each key on the keypad to operate the X-Sight please be aware that you need to tap each key. To turn OFF your device please press and hold the POWER button – you will see “device shutting down” with a count down, please continue to hold the POWER button throughout the entire cycle. To turn ON your device please press and hold the POWER button.

Xscope bpro software#

When you first turn the device on after program software updating Wi-Fi > Motion Sensing Platform configuration takes place. NOTE Wi-Fi / Motion Sensing platform configuration when first turned on. NOTE If the device does not restart within 30 seconds after reaching 100%, remove and re-insert the batteries and power-up the device. Please remember to delete the Firmware File off of the microSD card after all steps are completed.

Xscope bpro update#

Once the Firmware update completes, please do a factory reset before using the product.Motion Sensing platform will be configured when first turned on.After completing it will automatically restart and will be ready for use.Once the device is powered up it will enter self configuration mode.When the update counter reaches “100%” the device will automatically restart.In the “Firmware Update” dialog box select “Yes” to start the update.

Xscope bpro download#

Download the ***.bin file from (You may need to create an account, if you didn’t create it earlier) and copy to your microSD Card - root directory.

In the event of a power failure during an update the X-Sight may crash corrupting its system files and will need to be sent back to the ATN factory for service. NOTE You must make sure that the batteries in the X-Sight are fully charged before updating your device. NOTE Before operating your X-Sight please update the firmware to the latest version. You will also receive email announcements once a new firmware becomes available. Once you register you will be able to download the latest firmware file. To receive the notification of new firmware updates, please register your X-Sight HD by clicking REGISTER. NOTE If you are going to record video then microSD Card should be of Class 10 (10 mb/sec) or faster and have capacity from 4 to 64 Gb. When it pops up a few millimeters, it can pull with your fingers or tweezers. To remove the microSD card from the slot, push it in the same thin object. NOTE To lock when inserting microSD card in the slot, push it a thin object (a small coin, paper clip, toothpick, ballpen) until it clicks into place. A new microSD card should be formatted before using. Do not force the card into the slot as it may damage both the camera and the microSD card. NOTE There is only one correct direction to insert the microSD card. Do not over tighten as it will be difficult to remove. Make sure that the X-Sight HD is turned OFF before inserting the card into the slot.

Remove X-Sight HD has microSD, microUSB and Micro HDMI ports cap by unscrewing it counter clockwise.

NOTE You must have an SD card inserted in the device in order to be able to update the scope with the latest firmware as well as utilize the WiFi mode. X-Sight HD has microSD, microUSB and microHDMI ports. They will provide much longer battery life. NOTE We highly recommend using lithium AA batteries. Do not over tighten as it will be difficult to remove the next time you replace batteries.

Remove the battery cap by unscrewing it counter clockwise.

The X-Sight HD will operate on four AA type batteries. Ensure that all optical surfaces are clean and ready for use.

Inspect the scope for obvious evidence of damage to optical surfaces, body, eyecups, operation buttons, etc.

If any accessories are missing do not hesitate to contact ATN’s Customer Service at or 1-80. Open box, remove the X-Sight HD and check that content of box that nothing is missing.The following steps must be accomplished prior to each mission where the sight is used. Download this manual (.PDF, 2.20 Mb) Unpacking